Fluke 789 ProcessMeter

  • Fluke 789 ProcessMeter

Fluke 789 is both digital multimeter and a loop calibrator which has 2 to 20mA sink and source capability, including a 24V (Loop) supply. HART 250 resistor, 20mA drive into 1,200. Simultaneous mA and % of scale readout on mA output. 25% manual step plus auto step and auto ramp on mA output. Min/max/average/hold/relative modes. Double size dual display. Accuracy, VDC 0.1% +1, VAC 0.7% +2, mA DC 0.05% +2, frequency 0.005% +1.

Related Products

DRUCK DPI612 70 BAR PRESSURE CALIBRATOR

DRUCK DPI612 70 BAR PRESSURE CALIBRATOR

Fully self-contained pressure test and calibration system combines pressure generation, signal measurement and loop power. 0 to 70 bar, accu..

Druck DPI611 2 Bar Pressure Calibrator

Druck DPI611 2 Bar Pressure Calibrator

Fully self-contained pressure test and calibration system combines pressure generation, signal measurement and loop power. Generates from..

Emerson AMS Trex Device Communicator with HART

Emerson AMS Trex Device Communicator with HART

Intrinsically safe HART device communicator. Allows technicians to configure, isolate, diagnose and repair problems while devices continue t..

Emerson 475 HART and FF communicator

Emerson 475 HART and FF communicator

Discontinued & Unavailable for rental: The Emerson 475 has been replaced by the Emerson AMS Trex.Emerson AMS Trex Device Communicator..

Tags: fluke 789, fluke 789 process meter, process meter, multimeter